M10 x 30mm Phillips Raised Countersunk Screws (DIN 966 / ISO 7046-2) - Marine Stainless Steel (A4) Description

The M10 x 30mm Phillips Raised Countersunk Screws (DIN 966 / ISO 7046-2) - Marine Stainless Steel (A4) has the following features:

• DIN 966 / ISO 7046-2 Manufacturing Standard
• 30mm Length (L)
• Marine Stainless Steel (A4) Material
• Marine Stainless Steel (A4) Material Specification
• 1.5mm Pitch
• PH4 Drive Size
• Natural Finish
• 2.5mm Raised Length (R)
• Metric Metric or Imperial?
• M10 (10mm) Thread Size
• 18mm Head Diameter (D)
• 5mm Countersunk Length (H)
• 90 Degrees Countersunk Angle (CA)
• 17.78mm Head Diameter (Min) (D)
• 18.3mm Head Diameter (Max) (D)
• +2/-0 Degrees Countersunk Angle (CA) Tolerance

Discover more about the Metric Phillips Raised Countersunk Screws range.

Accu’s Metric Phillips Raised Countersunk Screws are designed to be used alongside our Phillips Head Screwdrivers and Phillips Head Drive Bits. The countersunk head of these components allows them to sit flush with the target housing, and the raised head gives an aesthetically pleasing appearance when installed.

In addition to Stainless Steel, Phillips Raised Countersunk Screws are available in a variety of materials, including Aluminium, Brass, Phosphor Bronze and PEEK. Additional coatings and finishes are available, including Chemical Blackening and Thread Locking Patches.

Metric

Metric Phillips Raised Countersunk Screws are manufactured according to DIN standard 965H. Thread sizes of between M2 and M10 are available, and lengths range from 3.00mm to 100.00mm as standard.

Imperial

Imperial Phillips Raised Countersunk Screws are compliant with ANSI B18.6.3. Diameters of between No. 2 and ¼ inch, and lengths from 3/16 inch up to 2.1/2 inch are available as standard. Non-standard dimensions can be manufactured on request.